Administrative overview · FIPS 37077
Granville County permit authority
The first compliance decision is jurisdictional: identify the office with statutory authority over your parcel, then use its filing and inspection sequence to keep the project moving.
Jurisdictional status
County
This county profile is the primary starting point for unincorporated-area permitting.
Responsible agency
Granville County Building Code Enforcement / Inspections Department
For a project in or near Granville County, this office is the identified point of contact for permit intake, statutory code enforcement, plan review coordination, and inspection release conditions. Confirm the parcel’s boundary and project type before relying on the county lane.
Direct contact
919-603-1326 (Inspections); 919-603-1331 (Planning/Zoning)
Call before mobilizing if the project has a boundary, occupancy, fire, septic, or utility question.
Permit counter
122 Williamsboro Street, Oxford, NC 27565
Operating hours
Permit office hours are 8:30-11:00 a.m. and 2:00-4:00 p.m.; the department recommends contacting inspectors around 7:30-9:00 a.m. or 2:30-3:30 p.m. because schedules vary.
Review expectation
Allow 5-7 days for residential plan review and a minimum of three weeks for non-residential plan review. Permits expire after six months if work has not started, and an inspection must be recorded within six months of issuance to keep the permit valid.
Compliance workbench
Choose the next project decision.
Apply online
Open the verified digital gateway, application form, and review timeline.
Open guide →Fees & penalties
Understand fee schedules, enforcement exposure, and stop-work liabilities.
Open guide →Codes & exemptions
Read the code framework, minor-work exemptions, and inspection lane.
Open guide →Agency website
Visit the primary public source for current notices and contact changes.
Open guide →Source trail
Official sources for this profile
Use these direct agency or licensing links to confirm current instructions before you file, pay, or schedule work. External pages control if their information differs from this directory.
Project questions
Frequently asked questions for Granville County
Who handles permitting for this jurisdiction?
Granville County Building Code Enforcement / Inspections Department is the identified county-level authority for this profile. Confirm that the property is in its service area before filing.
How should I begin an application?
Begin with the online permit gateway listed in the application guide. If the portal does not recognize the address or project type, contact 919-603-1326 (Inspections); 919-603-1331 (Planning/Zoning).
How long might review take?
Allow 5-7 days for residential plan review and a minimum of three weeks for non-residential plan review. Permits expire after six months if work has not started, and an inspection must be recorded within six months of issuance to keep the permit valid.
How are inspections scheduled?
Schedule inspections by calling 919-603-1326 and providing the current permit number. Reinspection fees must be paid in the office, by mail, or online before a final inspection can be scheduled. Granville County requires one plan set for residential review and three for non-residential review.
Which codes and exemptions should I review?
Granville County Building Code Enforcement administers the North Carolina State Building Code together with applicable county building, zoning, and land-use ordinances. Specific 2026 code edition: N/A. A building permit is not required to replace house shingles only, replace deck boards only, or install a portable lightweight aluminum carport not exceeding 400 square feet or 12 feet mean roof height; zoning approval may still be required. A fence does not require a building permit but does require a zoning permit. Storage buildings over 12 feet in any dimension, decks, pools, bonus-room finishes, and most structural or trade work require permits and any required zoning/health approvals.